Wipers and washers

NOTICE

•

Remove snow and ice from the windshield before driving. Using the wipers with snow or ice in the way can damage the wipers.

•

Use washer fluid with anti-freeze mixed in during freezing temperatures. Failure to do so can cause damage to the washer fluid system.

•

Keep the windshield clean. Failure to do so could damage or alter the performance of the wipers.

•

Clean and check the wiper blades regularly. Failure to do so could cause them to prematurely fail or not function properly.

•

Do not try to spray washer fluid when the washer fluid tank is empty. Doing so will damage the washer fluid nozzles.

•

Use washer fluid with antifreeze when the temperature is below 0°C. Otherwise, the pump, the reservoir, and/or the hoses can freeze, which could cause damage to the washer fluid system.

The wipers and washers are important to maintaining good driving visibility through the windshield.

The outer dial controls the front windshield wipers.

Setting	Function
	High speed
	Low speed
	Automatic
	Off

Press and hold the washer button

on the outside of the left stalk to activate the front washers for as long as the button is held. Briefly press the button to activate the wipers for one cycle.

If the wipers are set to automatic mode

, the rain and light sensors on the windshield will control how often the wipers swipe across the windshield.

To adjust the sensitivity of the automatic mode:

Navigate to

>Vehicle>Basic.

Adjust the Auto wiper sensitivity setting.

The switch in the middle of the left stalk controls the rear windshield wiper and washer. To activate the washer, push and hold the switch all the way up or down.

Setting	Function
	Rear washer
	Rear wiper
	Off